MiniHawk-VTOL Assembly in 100 Seconds

This sequence captures the essential elements of the MiniHawk-VTOL build steps. Print your own using the STL files here: Some details are not included in the CAD model, as follows: - The FPV VTx and the Antenna are not shown. - Screws/Bolts are not shown. - Hinge Reinforcement Tabs are not shown. - The Motor Tilt Mount/Holder is made from two pieces, not shown here. - The Pitot Probe Pressure sensor is placed in the same pocket as the GPS, not shown. - Wiring is not shown. - The Ball Stud and Link/Race piece are dissimilar here. - The Autopilot shown is the old 2015 PixRacer; this would not work in real life and is only a placeholder here. - The R/C Receiver is not shown. - No tape is shown; all the conduits on the bottom wing surface are covered with tape. - Acute details are not shown: Using Threadlocker compound on screws/bolts, where to place the antennas, drilling holes for antenna wires, reaming various holes.... the