I make an Industrial Style Coat Hook using Rebar - MIG Welding Project
In this video, I make an Industrial Design Coat Hook, using a rebar rod to give it the real industrial decor look. It was a good welding project for me, I did not heat the steel for bending I just used bits of pipe that slid over the rebar to get the leverage for the bend.
The steel plate is 3mm thick, 105mm long, and 42mm wide.
The Rebar is 13mm rebar
Main tools used, Welding Magnets V-Pads, MIG welder, angle grinder, Hammer, and a Drill.
Tools / Supplies, I often use are.
Marking out Tools
Markal Silver-Streak Metal Marker Round:
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens:
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack:
Locking Pliers – Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw:
Milwaukee 6“ Long Nose Locking Pliers:
Milwaukee 6” Locking Clamp Regular Jaws:
KNIPEX