Forge / Furnace turbo gas burner DIY jet propane

how to make a propane burner? Propane torch with 1 “tube, 1-1 / 4 to 2“ adapter, M10x90mm bolt, M10 nut, large washer and welding nozzle. All of these can be found inexpensively at a home improvement store. It is the most efficient and easy to manufacture turbocharged gas burner. It will easily melt aluminum if you need it. Manufacturing takes only half an hour. If you do not have a machine, you can use a smaller diameter adapter and pick up a finished washer. Tested on gas at 0.5 bar (approx. 7 psi). It can increase the flame by increasing the pressure, but I think this is enough to heat a forge or furnace. I can regulate the propane flow with the pressure regulator between the gas tank and the burner. Attention! If you have a galvanized burner nozzle like mine in the video, then I recommend that you remove the zinc coating before using this gas burner Thanks a lot for watching, I hope you liked the video! Suggestions and comments are welcome. Leave a like and sh