Making Vertical Bit Drawer / DIY

Please turn on your language subtitles! I use a lot of bits such as drill bits and cross bits and hole saws. It was always difficult to store these bits. When I tried to put it in a holder and use it, the space became too wide, so it was inconvenient, and it was difficult to find what I needed if I put it in a drawer. So, I made a vertical drawer with acrylic as the basic storage base. Taking advantage of the characteristics of transparent acrylics, LED was installed on the floor to light up the floor, and especially, the wiring such as LED was used for the drawer rail itself. I focused on the fact that the drawer rails always consist of two sets. The wiring became very easy, and there was no interference from the wires when pulling out the drawers, so it became comfortable. I also attached a clickable lead switch to the rear of the drawer rail so that it can only light up when the drawer is opened. And so that the switch can operate stably, I used the damper rail to allow the drawer rail to close on its own where the last switch is operating. I attached a magnet to the bottom of each acrylic base, which was made detachable, so that not only the bits could be stored, but also the bits that I used could be easily taken out and used. The advantage is that it takes up less space, and it’s pretty beautiful looking like Mac Pro. It’s a product that is at the forefront of the complete drawing among the works I’ve made. If there’s a lot of support from you, I’m considering mass-producing it as a selling product. I recommend you to refer to the video and make it yourself. Thank you. #DIY #BitDrawer #Storage #Bit_Storage #Luxury_Bit_Storage #Wood_DIY #Making #Howto