I mod my PS4 Controller to USB-C with Power Delivery!

In this episode, we will try to mod my beloved Playstation 4 controller to USB-C. I hate the fact that micro USB needs the correct orientation to connect. We will try to use a USB-C connector breakout board to accomplish this goal. Can We Mod It? We will see... 00:00 Introduction 00:33 Disassemble the controller 03:04 Get pinout 04:56 Remove the old port 06:46 Reseat and install new USB-C port 13:11 Measure values after soldering 14:37 File the port opening of the controller 16:19 Solder USB-C port and take measurements 19:48 Test charging 22:45 Mount the USB-C port and reassemble 26:40 Reassembly issue and fault finding 35:07 Test again Here are some of the used tools (affiliate links): USB Type-C USB-C 14 pin Connector Breakout Micro USB test board USB-C test board 0402 SMD 5.1 kOhm Resistor (choose correctly) Gamepad Tester *DISCLAIMER* This video is for demonstration purposes only and any actions taken as a result of viewing this video are done at your own risk. The content shown in this video should not be considered as professional advice or instruction. We are not responsible for any harm or damage that may result from following the information presented in this video. It is important to note that laws and regulations may vary by country and it is the viewer’s responsibility to ensure that any actions taken are in compliance with the laws of their own country.“ #ps4 #playstation #ps4mods #usbc #mods #playstation4