Carving Logo and Filling With Epoxy

Carving the Toolstoday logo using the Amana Tool item no. 45624-K 60° Spektra™ coated v-bit from the Toolstoday Website! **What do you think of how this logo turned out? - - - - - - - RPM: 18,000 Feed Rate: 40ipm Plunge Rate: 20ipm Depth of Cut: .21“ - - - - - - - This bit left a very clean cut that was filled with Total Boat 2:1 epoxy and some pure white Black Diamond Pigment. Find the epoxy here - After the epoxy cured I flattened it off with the item no. RC-2255 2.5“ Diameter 3 wing insert carbide flattening bit available from Toolstoday. - - - - - - - RPM: 18,000 Feed Rate: 190ipm Plunge Rate: 80ipm - - - - - - - I used a couple of pieces of blue painters tape to offset the touch off probe so it didn’t potentially hit any new wood. Flattening this saves a lot of sanding as the epoxy is not easy to remove. After flattening 20 seconds of sanding with 220 grit and this tray is ready for f