How to: 10 Inch Off Road Lift Fabrication - Chevy K20 Diesel Cummins Swap Squarebody Ep. 2

The diesel swapped Chevy Squarebody is back for one final installment as we finish up the 10“ Off Road Design lift installment. If you watched the first episode where we got the rear portion of the lift installed, you know that even though these parts come as a kit from ORD, there is a ton of chopping, welding and fabrication needed to make these parts work. So there’s a whole bunch of work to get done to get this truck leveled out and back on the road. We’re wasting no time getting the front torn down to be able to get all the brackets fitted up to bolt in our massive King Shocks. We’re measuring out our distance to get our bump stops welded in, then measuring in the opposite direction to find a good length for our limit straps. And that’s just the tip of the ice burg! By the time the episode is over, this Cummins swapped Chevy is rolling down the road and looking ready for some even bigger tires! Have any questions about this huge lift kit? Leave them in the comments!